2″ x 2″ grid pattern .118 welded galvanized wire clamped into 2 1/4“ 6063-T6 aluminum side rails.
Request a Quote
Attached Cage
The fall cage is welded directly to the retainer cap of the skylight
Cage Only
Attached over the top of the skylight’s existing retainer cap using screws.
Fasten #8 x 3/4″ – 1″ (depending on existing frame conditions) Hex Head Zinc Plated, Self-Drilling Tek Screws in each slotted hole on the fall cage retainer frame and into the existing skylight system. Screws are not included with the cage.
The fastener and frame should fit snug against the existing unit.
Frame Finishes
Mill only (unpainted metal)
Where to Measure
Please provide the measurement of the existing retainer cap and base frame. Outside edge to outside edge for both measurements.
